Replacing The Shear Pins (33, 48); Help In Case Of Malfunctions; Storage - AL-KO SnowLine 560 II Betriebsanleitung

Help in case of malfunctions

4. To check the setting, start the engine and
switch on the travel/auger drive.
5. If the travel/auger drive still cannot be proper-
ly engaged, the appliance must be taken to a
specialist workshop.
9.4

Replacing the shear pins (33, 48)

For the safety of the operator and appliance, the
shear pins (33/1) can break after a blockage of
the transport auger.
NOTE Replace broken shear pins with OEM
spare parts. Use of non-approved spare parts
can result in serious damage to the appliance!
1. Switch off the appliance and remove the
spark plug connector.
2. Remove the cotter pin (48/1).
3. Pull out the damaged shear pins (48/2).
4. Inspect the shaft for damage.
5. Insert a new shear pin and secure with cotter
pin.
10 HELP IN CASE OF MALFUNCTIONS
CAUTION! Risk of injury. Sharp-edged
and moving appliance parts can lead to injury.
■
Always wear protective gloves during mainte-
nance, care and cleaning work!
■
Switch off the engine and check that the en-
gine is at a standstill!
■
Remove the spark plug connector!
NOTE For malfunctions that are not listed in
this table or that you cannot resolve yourself,
please contact our customer service.
Malfunction
Engine does not
start.
Engine loses
power.
469186_f
Remedy
Fill with petrol.
Move the throttle lever to
the "Start" position.
Switch on the choke and
press the primer button.
Service the spark plug.
Clean the discharge chan-
nel/housing.
Clear snow and ice from
the transport auger and
discharge wheel.
Malfunction
Travel drive
does not func-
tion with clutch
lever pressed.
Travel drive can-
not be stopped
(does not disen-
gage).
Transport auger
does not rotate
with clutch lever
pressed.
Transport auger
cannot be
stopped (does
not disengage).
Abnormal appli-
ance vibrations.
Appliance pulls
to one side.
Replacement parts
See: www.al-ko.com

11 STORAGE

WARNING! Danger of explosion and fire.
Petrol vapours are highly inflammable.
■
Do not store the appliance close to naked
flames or sources of heat.
Thoroughly clean the appliance after each use
and – if present – attach all covers. Store the ap-
pliance in a dry, lockable place out of the reach of
children.
Remedy
Reduce the working speed.
Adjust the Bowden cable.
Take the appliance to a
Customer Service Centre.
■
Switch off the engine.
■
Do not try to repair the
appliance yourself!
■
Take the appliance to
a Customer Service
Centre.
Shear ping broken; replace
the shear pin.
Adjust the Bowden cable.
Take the appliance to a
Customer Service Centre.
■
Switch off the engine.
■
Do not try to repair the
appliance yourself!
■
Take the appliance to
a Customer Service
Centre.
Inspect transport auger
and discharge wheel.
Check tyre pressure and
correct, if necessary.
Check the skids and adjust
or replace, as necessary.
39