NSK Primado2 Bedienungsanleitung Seite 23

6-2 Adjusting the Motor
Touch the Motor Set Up Button in the Option Set Up screen to display the Motor Set Up screen.
Motor Set Up Screen
6-2-1 Setting methods for Acceleration, Brake, Torque and Oscillating Turns
Push the UP/DOWN Button to set the desired value.
When two Motors are connected to Motor Connector A and B, the Motor to be set up can be selected by the Motor Select Button in the
Sub Panel.
• Acceleration adjustment:
The acceleration time for the Motor to reach its maximum rotational speed can be set at any level between 10% and 100%.
• Brake adjustment:
The time it takes for the Motor to stop can be set at any level between 10% and 100%.
• Torque adjustment:
The torque level of the Motor can be set between 30% and 100%.
• Oscillating turns adjustment:
The oscillating turns can be set between 1 and 5 (This is available only when the P200-WPD Wire Pin Driver is connected).
● While the Motor Set Up screen is displayed, the Motor can be started. Prior to using the Motor, be sure to return to the
CAUTION
HOME screen.
6-2-2 How to return to the Factory Default settings
Touch the Factory Default Button and then the YES Button to
return to the Factory Default settings provided before delivery.
Touch the NO Button to keep the current settings.
6-3 Setting Up the Attachment
By setting up the connected Attachment, the optimal rotational speed for the particular Attachment becomes available. After setting up the
Attachment in the Attachment Set Up screen, return to the HOME screen to adjust the rotational speed and the Irrigation volume.
When two Motors are connected to Motor Connector A and B, the Attachment to be set up can be selected by the Motor Select Button in
the Sub Panel.
Touch the Attachment Set Up Button in the Option Set Up screen to display the Attachment Set Up screen.
● The settings of the Attachment are reset whenever the power is turned off or the Motor is disconnected from the Control
CAUTION
Unit. Prior to using the Attachment, be sure to confirm the current settings.
● If the Motor is not connected, a message alert announcing that the connection is not made will be displayed in the Main
Panel.
22
Acceleration Area
Brake Area
Torque Area
Oscillating Turns Area
Factory Default Button
Motor Select Button
Fig.34
Fig.35