NSK Primado2 Bedienungsanleitung Seite 15

P200-BMH and P200-BMH-HS Attachments
<Mounting>
1) Push the Attachment into the Motor straight.
2) Turn the Attachment rightward or leftward so that the Alignment Pin of the Motor
matches the hole of the Attachment with a clicking sound to connect firmly.
3) Tighten the Removal Ring of the Attachment manually to fix it firmly.
<Removing>
Loosen the Removal Ring and pull out the Attachment from the Motor Straight.
P200-WPD Attachment
<Mounting>
Insert the Attachment straight into the Wire Pin Driver until it
clicks.
* Wire Collet or Pin Collet should be mounted with the
Attachment Lever facing down (Motor Cord side).
<Removing>
Pull the Attachment straight out while pressing the Mounting/
Removal Button of the Wire Pin Driver.
3-5 Mounting of the Irrigation Pole
Match the position of the convex part on the Irrigation Pole with the position of the groove in
the Irrigation Pole Stand located at the back of the Control Unit, and insert the Irrigation Pole
into the hole.
3-6 Mounting of the Irrigation Tube
1) By rotating the Knob towards OPEN, open the Pump Cover.
2) Insert the Irrigation Tube (part with no blue line) into the Irrigation Pump in such a manner that the needle side of the Irrigation Tube is
positioned on the right-hand side of the Pump, and securely place the stopper of the Irrigation Tube into the Guide Parts located at both
ends.
3) Rotate the Knob towards CLOSE to close the Pump Cover.
14
Knob Knob
Fig.10
Alignment Hole Alignment Hole Alignment Pin
CLOSE CLOSE
OPEN OPEN
Attachment Attachment
Attachment Attachment
Wire Pin Driver Wire Pin Driver
Guide Parts
Roller
Attachment Side
Alignment Pin
Motor Motor
Fig. 7
Mounting/Removal Button Mounting/Removal Button
Fig. 8
Convex part on Convex part on
the Irrigation the Irrigation
Pole Pole
Groove in the Groove in the
Irrigation Pole Irrigation Pole
Stand Stand
Fig. 9
Irrigation Tube
Needle Side
Stopper
Irrigation Tube (with
no blue line)
Fig.11
Knob Knob
Fig. 12