Electrical Connection - Scheppach TBT19Vario Original Bedienungsanleitung

10. Electrical connection

The electrical motor installed is connected and ready for opera-
tion. The connection complies with the applicable VDE and DIN
provisions. The customer's mains connection as well as the ex-
tension cable used must also comply with these regulations.
Important information
In the event of overloading, the motor will switch itself off. After a cool-
down period (time varies) the motor can be switched back on again.
Damaged electrical connection cable
The insulation on electrical connection cables is often damaged.
This may have the following causes:
• Pressure points, where connection cables are passed through win-
dows or doors.
• Kinks where the connection cable has been improperly fastened or
routed.
• Places where the connection cables have been cut due to being driven
over.
• Insulation damage due to being ripped out of the wall outlet.
• Cracks due to the insulation ageing.
Such damaged electrical connection cables must not be used and are
life-threatening due to the insulation damage.
Check the electrical connection cables for damage regularly. Ensure
that the connection cables are disconnected from electrical power
when checking for damage.
Electrical connection cables must comply with the applicable VDE
and DIN provisions. Only use connection cables with the marking
„H05VV-F".
The printing of the type designation on the connection cable is man-
datory.
 www.scheppach.com /  service@scheppach.com /  +800 4002 4002
GB | 61