Scheppach TBT19Vario Original Bedienungsanleitung Seite 48

• Set the correct speed before starting work. The speed must be
appropriate for the drill diameter and the material to be drilled.
At an incorrectly set speed the bit may get jammed in the workpiece.
• Only when the device is turned on should the bit be moved
against the work piece. Otherwise there is a danger that the bit will
get jammed in the workpiece and the workpiece will rotate with the
bit. This can lead to injuries.
• Do not put your hands in the area of the drill while the power
tool is running. Upon contact with the bit is a risk of injury.
• Never remove drilling chips from the drilling area while the pow-
er tool is running. Always put the drive mechanism in the standby
position first and then turn on the power tool.
• Do not remove accumulated drill chips with your bare hands.
There is a risk of injury due to hot and sharp metal shavings in par-
ticular.
• Break up long drilling chips by interrupting the drilling operation
with a short backward rotation of the rotary wheel. Long drilling
chips may cause injury.
• Keep handles dry, clean and free from oil and grease. Greasy,
oily handles are slippery and lead to loss of control.
• Use clamps to hold the workpiece in place. Do not work on any
workpieces that are too small for clamping. If you hold the work-
piece by hand, you cannot hold it sufficiently tightly against rotation
and may hurt yourself.
• Switch the power tool off immediately if the bit jams. The bit
jams when:
- the power tool is overloaded or
- the workpiece to be machined is jammed.
• Do not touch the bit after working before it has cooled down.
The bit is very hot during use.
• Inspect the cable regularly and have a damaged cable repaired
only by an authorised customer service centre. Replace dam-
aged extension cables. This will ensure that the power tool remains
safe.
48 | GB
 www.scheppach.com /  service@scheppach.com /  +800 4002 4002