Scheppach TBT19Vario Original Bedienungsanleitung Seite 55

Installing the folding swarf protector and the drill chuck, Fig. 11
Push the folding swarf protector (11) onto the spindle on the machine
1.
head and use a Phillips head screwdriver to secure it.
Installing the chuck, Fig. 12
Clean the conical hole in the drill chuck and the spindle cone with a
1.
clean piece of cloth. Make sure that no dirt particles stick to the sur-
face. The slightest contamination on one of the surfaces prevents the
drill chuck from holding properly. This may cause the drill to hit. If the
tapered hole in the drill chuck is extremely dirty, use a detergent on
a clean piece of cloth.
Push the drill chuck onto the spindle nose as far as possible.
2.
Turn the outer ring of the chuck counter-clockwise (from the top view)
3.
and open the jaws of the chuck.
Place a piece of wood on the machine table and lower the spindle
4.
down to the piece of wood. Press firmly so that the feed fits strongly.
Insert/change battery: using the laser, Fig. 13
Insert/change battery: Switch off laser. Insert or remove the battery
1.
compartment cover (14.1). Remove batteries and replace with new (2
AA batteries).
To switch on: Move the ON/OFF switch (14) to the "I" position to
2.
switch on the laser. Two laser lines are projected on the workpiece
and intersect at the center of the drill tip contact point.
To switch off: Move the ON/OFF switch (14) to the "0" position.
3.
Installing the laser, Fig. 13
The laser can be adjusted using the adjusting screws (F).
Important: All bare parts are greased in order to protect them from
corrosion. Before mounting the drill chuck (12) onto the spindle, both
parts must be completely degreased using an environmentally friendly
solvent. This ensures optimal transmission of power.
 www.scheppach.com /  service@scheppach.com /  +800 4002 4002
GB | 55