Scheppach TBT19Vario Original Bedienungsanleitung Seite 54

Removing the rack, Fig. 4
In order to install your drill, you must first remove the rack (D)
1. Use an Allen key (SW3) to remove the ring (E) and pull this off the
column (2).
2. Now pull the rack (D) out.
Installing the drilling table holder, Fig. 5-7
1. Insert the rack (D) into the groove on the drilling table holder (4).
2. Align the rack (D) centrally in relation to the drilling table holder (4).
3. When bringing the rack (D) together within the groove, ensure that
the tooth meshing between the rack and the drilling table holder (4)
is correct.
4. Now place the drilling table holder (4) with the rack (D) on the column
(2) and guide the rack (D) into the bottom rack guide on the column
foot.
5. Use the ring (E) to secure the rack (D). Ensure that the rack guide on
the ring (E) is pointing downwards. Tighten the integrated Allen screw
to affix the ring (E).
6. Place the hand crank (16) on the shaft of the drilling table holder (4)
and secure it with the Allen screw. To do this, use the Allen key (B)
7. Screw one of the clamping handles (3) into the drilling table holder
(4).
Installing the machine head and column, Fig. 8
1. Place the machine head (13) on the column (2).
2. Align the drill's spindle with the table and the base plate and tighten
the Allen screw that is located on the side of the machine head. (Allen
key SW4 / A)
Installing the handles, Fig. 9+10
1. Screw three handles (10) tight in the handle bracket's thread. Use the
hexagon spanner to do this.
2. Screw the remaining handle (6) into the handle bracket for speed
adjustment. Use the hexagon spanner to do this.
54 | GB
 www.scheppach.com /  service@scheppach.com /  +800 4002 4002