Product Information - Ferm FZT-250N Gebrauchsanweisung

PRODUCT INFORMATION

1
2
6
7
5
Fig. A.
1 Top guard
2 Rip fence
3 Table insert
4 Bevel locking handle
5 Height adjustment/bevel adjustment handle
6 Measurement scale for fence
7 On/off switch
8 Bench protractor for mitring
9 Work table
Check first whether or not the delivery has been damaged
by transport and/or whether all the parts are present.
4
ASSEMBLY AND ADJUSTING
INSTRUCTIONS
3
8
9
4
8 mm
270 mm
Fig. B.
ASSEMBLY OF THE BENCH SAW ON THE WORK-
BENCH
Before adjusting the saw, make sure the plug is
removed from the socket.
Fig. B shows the distance of the holes to be drilled in the
workbench on which to fasten the machine. Drill holes of
8 mm.
415 mm
310 mm
270 mm
Fig. C.
Only use the machine after it has been assemb-
led completely and it has been screwed onto the
workbench or the frame.
- Fig. C shows the part to be sawn out (310 x 310 mm),
so that the sawdust can fall through it and piling up is
prevented!
Only if you do not use an extraction system!
- Fasten the machine with bolts.
Ferm Ferm
57