Technical Specifications; Product Information; Additional Safety Instructions - Ferm FRS-710 Gebrauchsanweisung

RECIPROCATING SAW
The numbers in the following text
correspond with the pictures at page 2

TECHNICAL SPECIFICATIONS

Voltage
Frequency
Power input
No load speed
Maximum cutting thickness
Stroke length
Weight
Lpa (sound pressure level)
Lwa (sound pressure capacity) | 103.3 dB(A)
Vibration value

PRODUCT INFORMATION

Fig.A
1. Blade
2. Footplate
3. Blade clamp screw
4. Trigger switch
5. Speed controller
6. Trigger lock button
7. Mains lead
8. Footplate length adjustment screws
9. 3 mm hexagon key (not s hown)
10. 4 mm hexagon key (not shown)
SAFETY INSTRUCTIONS
The following pictograms are used in these
instructions for use:
Denotes risk of personal injury, loss of
life or damage to the tool in case of
non-observance of the instructions in
this manual.
Denotes risk of electric shock.
Faulty and/or discarded electrical or
electronic apparatus have to be
collected at the appropriate recycling
locations.
Ferm
RSM1011 Ma # 0810-10.1 FC.indd 3
Carefully read this manual before using the
machine. Make sure that you know how the
machine functions and how to operate it.
Maintain the machine in accordance with
the instructions to make sure it functions
properly. Keep this manual and the enclosed
documentation with the machine.
When using electric machines always
| 230 V~
observe the safety regulations applicable
| 50 Hz
in your country to reduce the risk of fire,
| 710 W
electric shock and personal injury. Read the
| 600-2500/min
following safety instructions and also the
| 115 mm
enclosed safety instructions.
| 30 mm
Keep these instructions in a safe place!
| 3.3 kg
| 92.3 dB(A)

ADDITIONAL SAFETY INSTRUCTIONS

The machine must not be damp and must
| 11.3 m/s
2
not be operated in a wet environment.
Always inspect cable and plug before using
machine. Only have damage repaired by a
qualified professional.
Only insert the plug into the mains socket
when the machine is switched off. Wear
protective gloves and sturdy footwear.
•
•
•
•
•
•
•
•
•
Do not saw materials containing
asbestos!!!
Wear protective goggles when working with
materials which produce large amounts of
chips.
Wear a protective mask when sawing other
fibrous materials.
Portable equipment used outdoors must
be connected with a fault-current circuit
breaker.
Extension cables and plugs must be
approved for outdoors.
Remove adjusting keys and wrenches
before turning the tool on.
Secure your workpiece with clamps. Always
lead cable away from machine towards the
rear.
Move machine towards the workpiece only
when switched on.
Always hold machine with both hands and
ensure that you have a safe footing while
working.
The machine may be operated only with the
foot plate mounted. When sawing, the foot
plate must always rest on the workpiece.
GB
3
10/10/08 4:59:41 PM