Technical Data; General Declaration Of Conformity - Selve commeo SEE-com Originalbetriebsanleitung

Technical data/General declaration of conformity

6. Technical data

Series
1/10
2/7
2/10
2/15
2/20
2/30
Installation location:
After installing the drive, mark the drive type in the technical data table and make a note of
the installation location.
Not all motor types are available in all series and torques. Series 2 motors have a plugin con-
nection cable. Series 2 motors have a plug in connection cable. Series 1 and series 3 motors
have a 2.5 m mains cable as standard which is permanently installed and cannot be replaced.
The relevant cable lengths and qualities for series 1, series 2 and series 3 can be selec ted in
the catalogue.
Connection cables must be ordered separately.
Information about connections using special connectors must be requested.
Information for all motor types:
Nominal voltage: 230 V AC/50 Hz
Standby consumption: 0.5 W
Safety class: IP 44
Operating time: 4 min.
Radio frequency: 868.1 MHz
Max. transmission output: 10 mW
Note: The maximum radio range is up to 25 m indoors and up to 350 m in the open field.
Subject to change without prior notice!

7. General declaration of conformity

SELVE GmbH & CO. KG company, hereby declares that the SEE-com is in con formity
with the basic requirements and other relevant provisions of the Directive 2006/42/EG,
2014/53/EU, 2014/30/EU and 2011/65/EU. The declaration of conformity can be looked up at
www.selve.de
Torque Rotation speed
Nm Rpm
10 15
7 17
10 17
15 17
20 17
30 17
51
Power Input Output
A
0.5
0.41
0.55
0.66
0.75
0.95
115
95
124
152
172
220
EN