Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Operating and installation instructions
EN
Electrical / electronic systems
Work on electrical system parts may only be carried out by persons trained in electrical engineering. If maintenance work or
repairs are carried out, the unit must be switched to a de-energised, zero-potential state. If faults occur in the electric power
supply, switch off the unit immediately. Only use original fuses with the specified amperage. The electrical equipment of the unit must
be checked at regular intervals. Identified defects such as loose connections or scorched wires must be removed immediately. After
carrying out electrical work or repairs, the protective measures must be tested (e.g. earthing resistor).
Requirements with regard to the place of installation
The air humidification unit may only be installed in rooms where a water drain is available. Furthermore, safety precautions must be
provided for in the room, safely and automatically shutting off the water supply to the air humidification unit in the event of a leakage
(water stop valve). The air humidification unit is designed with the IP20 degree of protection.
5. Transport and storage
In order to prevent possible damage brought about by undue force during transport, the humidification unit must be handled with
care. If transported manually, ensure that necessary human lifting and carrying forces are reasonable.
The unit must not be transported by the connection cable. Avoid knocks and blows.
5.1. Dimensions and weight
Dimensions of the packaging unit (W x H x D)
Weight of the packaging unit without optional accessories
5.2. Packaging
The safety markings on the carton must be observed. Upon delivery, check the packaging and unit for possible signs of damage.
Complaints or damage must be reported immediately.
KWL
Hygrobox KWL HBX EH/WW
®
KWL HBX 250
800 x 460 x 420 mm
approx. 28 kg
8
KWL HBX 500
870 x 600 x 600 mm
approx. 62 kg
Werbung
Inhaltsverzeichnis
