Zipro Jogger Bedienungsanleitung Seite 33

EN
COUNTDOWN MODE
Press PROGRAM (P) / MODE (M) to select one of 3 countdown modes.
 Use SPEED +/- buttons to set the countdown value.

The treadmill and countdown will be started once you press START.
COUNTDOWN PARAMETERS
 H-1: TIME: the initial countdown value is 30 min.
The time can be set from 8 to 99 minutes (one-minute steps).

H-2: DISTANCE: the initial countdown value is 1 km.
The distance value can be set from 1 to 99 km (one-kilometer steps).
 H-3: CALORIES: the initial countdown value is 50 kcal.
The calories value can be set from 20 to 990 kcal (ten-kcal steps).
BODY FAT TEST
Press the PROGRAM (P) / MODE (M) button until FAT is displayed on the panel.
Use PROGRAM (P) / MODE (M) to enter parameters:
o F1 – gender – 01 male / 02 female
o F2 – age – 10–99
o F3 – height – 100–200
o F4 – weight – 20–120
Use SPEED +/- to set parameters.
After parameters are selected, „—" is displayed. Put both hands on the heart rate sensors.
After 5–6 seconds, the computer displays FAT information. FAT measures the relation between
your height and weight, not body proportions.
The correct result is between 20 and 25. A value below 20 means underweight, 26–29, overweight,
and above 29, obesity.
NOTE! The results must not be used for diagnostics or any medical purposes.
ENERGY SAVER
The treadmill computer automatically goes into the energy saving mode if no action is performed
within 10 minutes. Press any button to wake the system up.
POWER SUPPLY
Power cord 230V
Operating temperature 0 to +40°C
Storage temperature: -10 to +60°C
33