Yamaha WR426F 2001 Fahrer- Und Wartungshandbuch Seite 630

b
1
NOTE:
NOTE:
90˚
c
2
NOTE:
Apply the lithium soap base grease on the
throttle cable end and tube guide cable wind-
ing portion.
5 - 43
HANDLEBAR
2. Install:
Grip (left) 1
Apply the adhesive to the handlebar 2.
Before applying the adhesive, wipe off
grease or oil on the handlebar surface a
with a lacquer thinner.
Install the grip (left) to the handlebar so that
the line b between the two arrow marks
faces straight upward.
3. Install:
Grip (right) 1
Collar 2
Apply the adhesive on the tube guide
3.
Before applying the adhesive, wipe off
grease or oil on the tube guide surface a
with a lacquer thinner.
Install the grip to the tube guide so that the
grip match mark b and tube guide slot c
form the angle as shown.
4. Install:
Collar 1
Throttle cables 2
To tube guide 3.
CHAS