Inhaltsverzeichnis
Werbung
FRONT BRAKE ADJUSTMENT
NOTE:
If bleeding is difficult, it may be necessary to
let the brake fluid system stabilize for a few
hours. Repeat the bleeding procedure when
the tiny bubbles in the system have disap-
peared.
j. Add brake fluid to the level line on the
Check the operation of the brake after
bleeding the brake system.
3. Install:
EC362040
FRONT BRAKE ADJUSTMENT
1. Check:
Standard position
95 mm (3.74 in)
2. Adjust:
2
Brake lever position adjustment steps:
Loosen the locknut 1.
1
Turn the adjusting bolt 2 until the lever
position a is within specified position.
Tighten the locknut.
CAUTION:
Be sure to tighten the locknut, as it will
cause poor brake performance.
3 - 27
reservoir.
WARNING
Protector (rear brake)
Diaphragm
Master cylinder cap
Brake lever position a
Brake lever position a:
Extent of adjustment
Brake lever position
Locknut:
5 Nm (0.5 m • kg, 3.6 ft • lb)
INSP
ADJ
76 ~ 97 mm
(2.99 ~ 3.82 in)
Werbung
Inhaltsverzeichnis
