General Description; Scope Of Delivery - Parts List; Function Description; Overview - Parkside PLBA 20-Li A1 Originalbetriebsanleitung

for damage when the blower is not used
in conformity with its intended purpose or
due to incorrect operation.
The device is part of the Parkside X 20 V
TEAM series and can be operated using
X 20 V TEAM series batteries. The batter-
ies may only be charged using chargers
from the Parkside X 20 V TEAM series.

General description

The illustration of the principal
functioning parts can be found
on the front foldout page.

Scope of delivery - Parts list

Unpack the device and check for
completeness. Dispose of the packaging
material properly.
- Cordless Leaf Blower
- Blower pipe
- Instructions for use
Battery and charger
are not included.

Function description

The cordless leaf blower features a
blowing mechanism that allows foliage to
be quickly gathered or blown out of hard
to reach areas.
Refer to the following descriptions for a
functional description of the controls.

Overview

1 Blower pipe
2 Locking button
3 Motor housing
4 On/Off switch
5 Handle
6 Guide rail
7 Ventilation slits
8 Charger
9 Rechargeable battery
10 Button
11 Release buttons
12 Connector nozzle
13 Attachment

Technical data

Cordless Leaf Blower PLBA 20-Li A1
Motor voltage U ........................20 V
Current strength I ........................... 16 A
Rated speed n ......................12000 min
Air speed ........................ max. 210 km/h
Protection type................................. IPX0
Weight (without battery) .............. 1,33 kg
Sound pressure level
) ....................77,2 dB (A), K
(L
pA
Sound power level (L
guaranteed ............................ 83 dB(A)
measured .........83,2 dB(A); K
Vibration (a
) ........ 1,21 m/s
h
Attention! An up-to-date list
of battery compatibility can
be found at:
www.lidl.de/akku
Noise and vibration values have been de-
termined according to the standards and
regulations mentioned in the declaration of
conformity.
The stated vibration emission value was
measured in accordance with a standard
testing procedure and may be used to com-
pare one power tool to another. The stated
vibration emission value may also be used
for a preliminary exposure assessment.
GB CY
= 3 dB
pA
)
WA
= 0,2 dB
WA
; K= 1,5 m/s
2
-1
2
5