First Steps To Start F-Scan3 Nt - TB-ELECTRONICS F-SCAN3 NT Bedienungsanleitung

First steps to start F-SCAN3 NT

- Connect the mini usb cable to the device and plug the wall charger into a wall outlet with a reading
between 100 VAC up to 240 VAC.
- Touch the ON switch on the side.
The screen must show the stand by screen with the battery symbol top right flashing yellow.
The information displayed means:
- SERIAL: Serial number of device
- ONS: Number of uses
- Ds Number of DIRPs
- FLASH ID: identifies the type of internal memory.
FFFFFFFF would indicate a memory defect. The device must then be checked by a professional.
- V1.00Bxx Version of software active in the device.
The opening screen, as shown above, offers a menu of 5 or 6 options. One has to be selected with the finger to
continue the setup of the F-SCAN3 for operation. The menu button EAP is enabled only if the device is
purchased with the EAP option.
- 9 -