How To Complete An Eap-Table - TB-ELECTRONICS F-SCAN3 NT Bedienungsanleitung

How to complete an EAP-table

Starting with the left hand, each acupuncture point must be measured top down. Continue with the right hand,
the left and right foot. If the micro- processor identifies a measured value as EAP-like, it appears in the table and
the cursor-selection moves on to await the next value. If a point must be re-measured, the previous value
disappears after a touch on it.
NOTE: The procedure takes time. The measured value shown under the table block must have returned to 00
before the next point can be measured.
All measured values between 45 and 55 are considered to be within the "NORMAL RANGE". Values below 45,
or above 55, will be shown in red in the table.
The EAP menu can be switched from "HAND" to "FOOT" with the bottom right button.
The button CLEAR sets all entries to zero and re-starts at the first position of the page.
After finishing an EAP session, the button ANALYSE may be used to create a program which may be used as
specific application EAP in the actually selected memory slot. The contents of the memory slot will be overwritten
by this.
- 20 -