Factory Settings - TB-ELECTRONICS F-SCAN3 NT Bedienungsanleitung

Factory settings

Language on screen:
Application time per frequency:
Signal strength:
Signal form:
Memory of "123" is empty.
Memory of "ABC" is empty and locked.
Connector 3.5mm CON1 :
At this connector is the standard multi signal output available with a bandwidth up to 3 MHz. Standard
application parts may be connected.
Connector 3.5mm CON2 :
This connector is not applicable.
Connector 2.5mm on CON3 :
Connector for the PowerPort. Application parts such like magnetic field electrode must be connected here. No
standard application parts may be connected.
RESET: If device cannot be operated from the touch screen due to unknown reasons, the RESET button on
the rear panel can be pressed briefly to shut down the unit. Use a "tooth pick" or "match" carefully.
Such effects may happen if the battery has not been charged correctly or a data transfer from software was
interrupted.
English or German
3:00 Minutes
(adjustable between 0:30 and 59:59)
80% of maximum of 12Vpp
(adjustable +/- in steps of 1%)
AUTO (Sine, Square Full Wave, Half Wave, SMART and OFF selectable).
AUTO = Square Half Wave if lower than 65000 Hz, Sine above 65000 Hz.
- 8 -