Test Block - GF PF220 V2 Betriebsanleitung

Operating Instructions
Code is invalid
Unknown product
Illegal to edit or delete this information
ERR: unknown board type
Value out of bounds
System Error [nnnn]
13.4

Test Block

A test block is included with the flowmeter equipment to allow the transducers and inter-connecting cables to be functionally
checked.
1. Switch ON the instrument.
Quick start
2. Select
Parameter
Pipe outside diameter
Pipe wall thickness
Pipe lining thickness
Pipe wall material
Fluid type
Mode
Temp
3. At the end of the Quick Start procedure, the Summary screen is displayed. Press the UP or DOWN arrow
and enter the parameters shown in the table below for the appropriate transducer type (A or B):
A Sensors
30.0mm
14.0mm
Interpretation: Either the user or factory pin code is incorrect.
Response: Try again.
Interpretation: The board count for product does not match the prod-
uct type specified.
Response: This is a serious error. Restart the
flowmeter. If the problem persists, contact your
distributor for further advice
Interpretation: This field cannot be modified or deleted. This usually
occurs when trying to edit or delete the Quickstart site.
Response: None required.
Interpretation: Flowmeter internal error. The controller has attempt-
ed to request a board that does not exist.
Response: Reset the flowmeter to be safe.
Record the conditions under which the error
occurred and report them to the distributor when
convenient.
Interpretation: The values entered were out of bounds for this vari-
able. This error is similar to the error "
Limits are xx.x [text] to yy.y [text]".
Response: Enter a valid value.
Interpretation: A serious internal error occurred. This indicates and
error condition that should not be
possible. It may or may not be fatal.
Response: Record the error number and conditions that lead to the
error. Ideally turn the flowmeter off then on. When convenient report
the error number and conditions to your convenient report the error
number and conditions to your distributor.
0.00
PVDF-SYGEF
Water
Diagonal
20°C
Troubleshooting
B Sensors
50.0mm
22.0mm
59