GF PF220 V2 Betriebsanleitung Seite 34

Operation of the device
8.2.4 Changing a site name
Choose from list of sites
To change a site, select
the displayed list of current sites. Select the site name and press ENTER. You will be prompted to confirm your choice to modify the
name or exit the process. When changing the name, the same rules apply for the name as when adding a new site
8.2.5 Editing Site Data
View/Edit Sit
- >Choose from list of sites..
Add new site..
Site name..
Pipe outside diameter
Pipe circumference
Pipe wall material
Pipe Wall thickness
Lining material
Pipe lining thickness
Sensor set
Sensor mode
Fluid Type
Fluid Temperature
Cutoff Velocity
Roughness factor
Zero Flow Velocity
Zero Flow Offset
Calibration factor
RTD Settings..
Read flow using selected sensor..
Read flow using recommended sensor..
Delete this site..
Exit
NOTICE
If you select a different sensor set (e.g. A-ST) when entering new site data you could receive an
"invalid" error message if the previous sensor set was operating at a temperature above 135 ºC. If this occurs, ignore the warning
as it will disappear when you enter a temperature in the correct range for new sensors.
34
from the
DD-MM-YY HH:MM:SS
114.30 mm
359.08 mm
Plastic
8.00 mm
None
0.0 mm
A-ST
Reflex
Water
14.0 C
0.010 m/sec
00.0150 mm
-0.0140 m/sec
-5.1437 1/min
1.000
View / Edit Site Data
1. Having selected the appropriate site, scroll through the
menu list and enter/change the pipe, sensor and fluid
parameters.
• Pipe outside diameter
• Pipe circumference
• Pipe wall material
• Pipe wall thickness
• Lining material
• Pipe lining thickness
• Sensor set
• Sensor mode
• Fluid type
• Fluid temperature
2. When all the data is correct, choose one of the following
options:
a. Select RTD Settings to view the RTD configuration (GF
PF330 V2 models only).
b. Select Read flow with selected sensors to continue fitting
the transducers you have specified in the site description
and then open the FLOW READING screen.
Select Read flow with recommended sensors to view the
c.
optimum sensors and configuration for the parameters you
have specified in the site description.
d. Select Delete this site to delete the site from the site list.
You are prompted to confirm the action. Select Yes to
continue with the deletion or No to cancel the action and
keep the site. Press the ENTER key to continue.
Select Exit to return to the MAIN menu.
e.
Operating Instructions
menu. Select the required site from