Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Operation of the device
8.2
Managing named sites
Setting up the flowmeter using the Quick Start method described in the previous chapter is the recommended method to use in a
'one-off' situation.
If you want to monitor a particular site location frequently you can set up a named 'Site' to store the installation details, such as
pipe dimensions and material, required to set-up the flowmeter. These parameters can then be recalled later when revisiting that
particular location. The instrument can store up to 12 sites, the first site is reserved for QUICK START and cannot be renamed;
subsequent sites are initially named EmptySite1 through to EmptySite12.
8.2.1
View / edit site data
View/Edit Site Data
Use the
PF330 MAIN
Quick start..
- > View / Edit Site Data..
Setup Instrument..
Data Logger..
Read Flow..
Read Energy..
View/Edit Sit
- >Choose from list of sites..
Add new site..
Site name..
Pipe outside diameter
Pipe circumference
Pipe wall material
Pipe Wall thickness
Lining material
Pipe lining thickness
Sensor set
Sensor mode
Fluid Type
Fluid Temperature
Cutoff Velocity
Roughness factor
Zero Flow Velocity
Zero Flow Offset
Calibration factor
RTD Settings..
Read flow using selected sensor..
Read flow using recommended sensor..
Delete this site..
Exit
32
command on the MAIN Menu to display the View/Edit Site menu. This allows you to:
DD-MM-YY
HH:MM:SS
DD-MM-YY
HH:MM:SS
Quickstart
114.30
mm
359.08
mm
Plastic
8.00
mm
None
0.0
mm
A-ST
Reflex
Water
14.0
C
0.010
m/sec
00.0150
mm
-0.0140
m/sec
-5.1437
1/min
1.000
•
Manage site names.
The instrument can store up to 12 sites, the first site is
reserved for the default QuickStart site and cannot be renamed;
subsequent sites are initially named Site01 through to Site11.
•
Edit key parameters such as pipe outside diameter and wall
thickness.
•
Change calibration factors including Cut-off Velocity and
Roughness Factor.
Operating Instructions
Werbung
Inhaltsverzeichnis
Fehlerbehebung
