First-Time Use; Selecting A Language - GF PF220 V2 Betriebsanleitung

Installation
7.2

First-time use

Leave the instrument on charge for at least 15 minutes before using it for the first time.
Switch on the instrument by pressing and holding down the ON/OFF button for about 2 to 3 seconds. Wait for the banner screen to
be fully displayed. The battery symbol in the top right of the screen roughly indicates the level of the battery charge.
Press the ENTER key to display the Main menu.
7.2.1 Checking system health
This operation should be checked after powering up the unit for the first time, but it is useful to check periodically that all systems
are operating properly, especially if errors were reported when entering the Main menu.
CHARGING
7.2.2

Selecting a language

English is the default display language. German, French and Spanish options are also available. To change the language:
PF330 MAIN
Quick start..
View / Edit Site Data..
- > Setup Instrument..
Data Logger..
Read Flow..
Read Energy..
Options
- > System..
Power..
Output..
Heat-Meter..
Logger..
Primary Flow..
24
DD-MM-YY HH:MM:SS
DD-MM-YY HH:MM:SS
DD-MM-YY HH:MM:SS
1. From the Main menu, use the Up and Down scroll keys to
select Setup Instrument. Press the ENTER Key.
2. A list of options will be displayed depending on the flow-
meter model. It should be noted that a status message will
appear to the right of the option name. If the sub-system
implementing the option is working correctly, the status
will read "OK". If any subsystem has a fault, two dashes
will be visible.
3. If a subsystem is NOT reading OK at start-up, try restarting
the flowmeter by turning it off then on again. If the error
persists, contact your distributor or return the item for
repair
1. From the Main menu, use the Up and Down scroll keys
to select Setup Instrument. Press the ENTER Key. With
System selected in the Options menu, press the ENTER
Key.
2. Alternatively, from a Read Flow/Velocity/Energy screen,
press the SYSTEM key (2). The System Settings menu is
displayed.
Use the UP/DOWN arrow keys to select Language. Press
3.
the ENTER key.
4. Use the UP/DOWN arrow keys to scroll through the
available options.
5. With the required language highlighted, press the ENTER
key
Use the UP/DOWN arrow keys to select Save Setup & Exit.
6.
Press the ENTER key.
7. The selected language is now active for all screens.
Operating Instructions