Selecting An Existing Site - GF PF220 V2 Betriebsanleitung

Operating Instructions
8.2.2

Selecting an existing site

View/Edit Sit
- > Choose from list of sites..
Add new site..
Site name..
Pipe outside diameter
Pipe circumference
Pipe wall material
Summary
Site: Quickstart
Sensor seperation 69.9mm
Pipe OD: 114.3mm, ID 98.3mm
Sensor Type A-ST, Mode: Reflex
Fluid type: Water @14.0 C
Press < - to continue <> to select sens.
NOTICE
The sensors screen can be entered by pressing either of the scroll keys. This allows the type and mode of the sensors being used
to be selected. Ensure that the sensors are connected properly.
NOTICE
Do not press the enter key until the transducers are fitted and connected to the instrument.
8.2.3 Adding a new site
To add a new site
View/Edit Sit
Choose from a list of sites..
- > Add new site..
Site name..
Pipe outside diameter
Pipe circumference
Pipe wall material
View/Edit Sit
I Input: Site01
0- / . 0
GHI 3
PQRS 6
NOTICE
This menu allows you to choose a sensor set, unlike the quick start wizard, which recommends the sensor set to use. If you enter
an inappropriate sensor set in this menu you will be presented with an error message later when you go to the sensor separation
screen and you will be unable to start reading flow.
DD-MM-YY HH:MM:SS
Site01
114.30
359.08
Plastic
DD-MM-YY HH:MM:SS
DD-MM-YY HH:MM:SS
Site01
114.30 mm
359.08 mm
Plastic
DD-MM-YY HH:MM:SS
ABC 1 DEF 2 'delete'
ABC 1 DEF 2 'delete'
TUV 7 WXYZ 8 9_
1. Select View / Edit Site Data from the MAIN MENU.
2. Select Choose from list of sites.
3. Use the UP/DOWN arrows to select the required site, then
press the ENTER key. The stored parameters are retrieved
from memory and displayed on-screen.
4. Scroll down through the menu list and enter or change any
mm
mm
data that might have changed since the last time the site
was accessed (see Managing Named Sites). Changes are
saved automatically only when entering the READ FLOW
screen.
5. Select Read flow using selected sensor or Read flow
using recommended sensor.
6. The Summary screen now displays some of the
parameters you may have entered and informs you of the
type of sensor to be used, the mode of operation and the
distance to set up between the sensors.
In this example, it recommends type A-ST (A standard)
sensors operating in the 'Reflex' mode spaced at 67.4mm
apart.
7. Press the ENTER key to display the READ FLOW screen.
1. Select View / Edit Site Data from the MAIN menu.
2. Select Add new site.
3. You are prompted to edit the Site name. Sites are initially
named Site01 through to Site11 using the numeric keypad
in a Multi-Press mode.
Each key represents three or more characters. For
example, "1" represents the characters ABCabc1.
Repeatedly press the same key to cycle through the
characters for that key. Pausing for a brief period of time
will automatically select the current character in the
cycle. Punctuation and special characters (such as "$","-
","/",".","_",":","#,"~", and more) can be accessed via the "0"
key, and spaces via the "9" key. Site names are limited to 8
characters, must contain no punctuation, and be unique.
4. A new site with the name supplied will be created using
default values for all parameters.
Operation of the device
33