Transport; Installation; Removing The Front Panel - STIEBEL ELTRON LWZ 180 Bedienung Und Installation

INsTALLATIoN

Installation
Installation drawing with silencer attachment
≥400
9.3

Transport

Material losses
!
If possible, transport the appliance to the installation lo-
cation in its original packaging.
If the appliance is transported without packaging and
without using a pallet, e.g. to carry it up or down stairs,
its outer casing may be damaged.
To transport the appliance without packaging, first re-
move the front panel of the appliance. See chapter "In-
stallation / Removing the front panel".
Material losses
!
Never use the air connections as handles for carrying
the appliance.
www.stiebel-eltron.com
10. Installation
379

10.1 Removing the front panel

147
Remove the front panel before removing the appliance from the
pallet, to avoid damaging the appliance.
≥400
1 Fascia
2 Front panel fixing screws
The fascia is fastened to the appliance with locking tabs.
f To disengage the locking tabs, press the grip areas on the
f Remove the fascia from the appliance.
f Undo both screws securing the front panel at the top of the
f Carefully push the front panel upwards by a small amount to
1 Plug on cable from programming unit to appliance
f Carefully raise the front panel by a small amount on the
LWZ 180 / L WZ 280 / LWZ 180 Enthalpie / LWZ 280 Enthalpie |
2
1
fascia sides.
appliance.
release it from the hooks on which it is engaged.
right-hand side.
2
1
39