Battery; Inserting And Replacing The Battery - VOLTCRAFT VC-890 Bedienungsanleitung

V
A
mA
µA
Hz
kHz
MHz
VA
%
ºC
ºF
Ω
kΩ
MΩ
nF
µF
mF
0 1 2 3 4 5 6

9. BATTERY

Before you can work with the measuring device, you must first insert the enclosed
battery.
a) Inserting and replacing the battery
A 9 V alkaline or lithium monobloc battery is needed to operate the measuring device. When using
for the first time or when the battery status symbol
new, full (rechargeable) battery of the same type. Also note the safety guidelines for (rechargeable)
batteries (page 53).
56
Volt (unit of electrical voltage)
Ampere (unit of electrical current strength)
Milliampere (=0.001 A)
Microampere (=0.000001 A)
Hertz (unit of frequency)
Kilo Hertz
Mega Hertz
Voltampere (unit of apparent electrical power)
Percentage display for duty cycle measurement
Degrees Celsius
Degrees Fahrenheit
Ohm (unit of electrical resistance)
Kilo Ohm (=1000 Ω)
Mega Ohm (=1000000 Ω)
Nanofarad (unit of electrical capacitance = 0.000000001 F)
Microfarad (=0.000001 F)
Millifarad (=0.001 F)
Symbol for the capacitance measurement range
Warning symbol for voltages >30 V/AC and >42 V/DC
Bargraph display (only for V, A, Ω)
Low pass filter for alternating voltage
Low imp function
(flat) appears in the display, you must insert a