Stiga TCHE 102-Serie Gebrauchsanweisung Seite 83

PROBLEM
7. E ngine stops when cutting
means are engaged
8. T he battery warning light does
not turn off after a few minutes'
work
9. T he oil warning light comes on
while working(if fitted)
10. T he engine stops and an
audible signal is heard
11. T he engine stops with no
audible warning
12. T he cutting means do not
engage or do not stop promptly
when they are disengaged
13. U neven mowing and poor
grass collection
14. U nusual vibrations while
working
15. Uncertain or ineffective braking
16. E rratic forward movement,
poor drive when going uphill or
if the machine has a tendency
to rear up
17. W ith the engine running, the
machine does not move when
the drive pedal is pressed
LIKELY CAUSE
– y ou are not ready to engage the
blade
– r echarging of the battery
insufficient
– p roblems in lubricating the
engine
The safety device of the electronic
circuit board has cut in due to:
– o vervoltage caused by the
charge regulator
– b adly connected battery (poor
contact)
– d isconnected battery
– p roblems in the engine
– loose belt
– p roblems in the electromagnetic
clutch
– c utting means assembly is not
parallel to the ground
– i nefficient cutting means;
– f orward speed too high
compared to the height of grass
being cut
– c ollector channel is blocked
– c utting-means assembly is full
of grass
– t he cutting means are
unbalanced or loose
– l oose bolts and screws
– t he brake is not adjusted
correctly
– p roblems with the belt or the
engagement device
– release lever in position «B»
19
SOLUTION
– c heck that all starting conditions
are met (see 5.2.)
– c ontact your dealer
– T urn the key immediately to
«OFF»:
– t op up the oil level (see 5.3.3)
– r eplace the filter (if the problem
continues, contact your dealer)
Turn the ignition key to the «OFF»
position
and look for the cause of the
problem:
– c ontact your dealer
– c heck connections (see 3.4)
– c heck connections (see 3.4)
– c ontact your dealer
– c ontact your dealer
– c ontact your dealer
– c heck the tyre pressure (see
5.3.2)
– r einstate the alignment of the
cutting-means assembly in
relation to the ground (see 6.3.1)
– c ontact your Dealer
– r educe the forward speed and/
or raise the cutting-means
assembly (see 5.4.5)
– w ait for the grass to dry
– r emove the grass catcher and
empty the collector channel (see
5.4.7)
– c lean the cutting means
assembly (see 5.4.10)
– c ontact your Dealer
– c heck and tighten all the engine
and frame bolts
– c ontact your Dealer
– c ontact your Dealer
– p ut into position «A» (see 4.34).