Technical Data - Protool IWC 18-2 TEC Originalbetriebsanleitung

Technical data

Battery-powered hammer screwdriver
- Original instruction
Motor voltage
Idling speed*
Speed under load
Impact rate
Torque - screwing into soft/hard material
Torque
Spindle
Max. drill diameter
Screws in spruce
Weight without battery
Accessories
Charger
Mains voltage (input)
Mains frequency
Charging voltage (output)
Rapid charging
Conservation charging current, pulsating
Charging times for:
LiIon 3.0 Ah
NiCd 1.3 Ah
NiMH 2.0 Ah
Permitted charging temperature range
Temperature monitoring
IWC 18-2 TEC battery packs
Voltage
Capacity
Weight
* Speed specifi cations with fully charged battery pack.
The specifi ed illustrations are at the beginning of this operating manual.
Table of contents
1 Symbols ............................................ 11
2 Machine features ................................ 11
3 Service description .............................. 11
3.1 Product features ................................. 11
3.2 Intended use ...................................... 11
4 Safety instructions .............................. 11
4.1 Machine-related safety instructions ....... 11
4.2 Emission levels ................................... 11
5 Commissioning ................................... 12
5.1 Changing the battery pack ................... 12
5.2 Charging the battery pack .................... 12
5.3 Charger wall mount ............................. 12
6 Settings ............................................. 12
6.1 Changing the direction of rotation ......... 12
6.2 Changing gear .................................... 12
6.3 Fastening ........................................... 12
6.4 Drilling .............................................. 12
6.5 Screw fastening and loosening .............. 12
10
1 gear
st
2 gear
nd
in wood
in metal
max. diameter
80% approx. 50 min.
approx. 25 min.
approx. 50 min.
IWC 18-2 TEC
0 - 400/min
0 - 2000/min
1700/min
3400/min
40/60 Nm
½" external square / ¼" internal hexagon
230 - 240 V ~
7.2 - 18 V =
approx. 0.06 A
NiCd 2.4 Ah
NiMH 3.0 Ah
−5 °C to +45 °C
via NTC resistor
BP 18 LiIon
7 Tool holder, attachments ...................... 13
7.1 Tool chuck CENTROTEC CC-IP ............... 13
7.2 Auxiliary handle .................................. 13
7.3 Tool holder in drill spindle .................... 13
8 Operation .......................................... 14
9 Service and maintenance ..................... 14
10 Transport ........................................... 14
11 Accessories ........................................ 14
12 Disposal ............................................ 15
13 Warranty ........................................... 15
14 EU Declaration of Conformity ................ 15
18 V
300 Nm
50 mm
12 mm
12 mm
1.5 kg
BC 3
50/60 Hz
max. 3 A
100% approx. 65 min.
approx. 50 min.
approx. 70 min.
18 V
3.0 Ah
0.715 kg
GB