Battery Charge Level Indicator; Changing The Chain Speed; Checking The Chain Brake; Checking The Oil Automatic System - Parkside PKSA 40-Li A1 Originalbetriebsanleitung

close securely over the handles.
6. To start the device, push the switch lock
( 3) forwards with the right thumb
and press the on/off switch (2). The de-
vice will run at top speed. Release the
switch lock (
7. The power saw switches off when you
release the On/Off switch (2) again.
Switching for continuous running is not
possible.
Battery charge level
indicator
Press the On/Off button (
The LEDs on the control panel
light up.
high low
high/low
The charge level of the batteries is indi-
cated by illumination of the corresponding
LED lights of the battery charge level indi-
cator ( 24).
3 LEDs illuminated (red, orange and green):
Battery charged
2 LEDs illuminated (red and orange):
Battery partially charged
1 LED illuminated (red):
Battery needs to be charged
Changing the chain
speed
The device automatically starts at the
higher chain speed (21 m/s). By pressing
the High/Low button (27), you can switch
between chain speeds (15 and 21 m/s).
The High or Low LED of the chain speed
indicator (25) shows which chain speed is
currently operating.
3).
Checking the chain
brake
The motor cannot be turned on if the
chain brake has engaged. Do not
employ the chain brake in order to
start the chainsaw or to switch it off.
1. Place the chainsaw onto a solid, flat
surface. It must not contact any objects.
2. Ensure that the chain brake has been
released, that is, that the chain brake
lever (5) is pulled up against the front
grip (4).
3. Hold the chainsaw firmly with both
26).
hands, with the right hand on the rear
handle (
front handle (
must close securely over the handles.
4. Turn on the chainsaw.
5. Activate the chain braking lever (5),
with running motor, with the left hand.
The saw chain should stop abruptly
and a warning tone sounds.
6. Once the chain brake is working prop-
erly, release the on/off switch (
and the chain brake.
If the chain brake does not
function correctly, you must
not use the chainsaw. A slack
saw chain leads to danger of
injury. Return the chainsaw to
our Service-Center for repair.
Checking the oil automatic
system
Check the oil level and the automatic oil
system before commencement of work.
• Switch on the chainsaw and hold it
above a bright background. The saw
must not touch the ground.
GB
1) and the left hand on the
4). Thumb and finger
IE
2)
45