Connecting The Computer - Sony UP-D2550S Gebrauchsanweisung

Connecting the Computer

The UP-D2550S connects the computer that supports the SCSI interface.
Before connecting the computer, see "Important safeguards/notices for use in the
medical environment" on page 2.
Notes
• Turn off the power of each device before attempting to make any connections.
• Grab the connector at the end of the connecting cable, and firmly insert it into the
socket.
• Before connecting the SCSI cable, make sure to turn off the power switches on
your computer and any peripheral equipment.
• The total length of the SCSI cabling used with a single-host computer should be
less than 6 meters.
• The length of the SCSI cabling used with a single-host computer should be less
than 1 meters.
Computer
SCSI cable
(not supplied)
to SCSI connector a)
a) If the printer is located at the physical end of the SCSI bus, this switch should
be set to ON. (see "Setting the DIP Switch" on page 12)
a)
SCSI ID DIP switch
AC power cord (supplied)
to wall outlet
to⁄AC IN
Preparation
13