Front Panel; Stop Button; Rear - Sony UP-D2550S Gebrauchsanweisung

7 Front panel

Pull the top on the front door toward you to
open it.
Opening the front panel reveals the ink ribbon
cartridge, paper tray and paper cover.
When the front panel is open
a

Rear

1
SCSI connector (Half pitch 50-pin) (13)
Used to connect a computer, or another
peripheral, through an SCSI cable. The other
connector is loop-through connector for
another SCSI device. If either of the two
connectors is not being used, set the
terminator of the DIP switch to ON.
(see "Setting the DIP Switch" on page 12)
2
SCSI ID DIP switch (13)
Used to set the SCSI ID number and the built-
in terminator to ON or OFF.
(see "Setting the DIP Switch" on page 12)
a Ink ribbon cartridge (11, 15)
b Paper cover (11)
c Paper tray (11, 18)
b

8 STOP button (21)

9 PRINT button (20)
c
3
4
Insert the ink ribbon cartridge.
Paper is ejected onto this cover.
Load paper into this tray.
Press to stop printing midway.
Press to print the image stored in the memory
of the printer again.
Equipotential ground terminal 1
Used to connect to the equipotential plug to
bring the various parts of a system to the same
potential.
Refer to "Important safeguards/notices for use
in the medical environment" on page 2.
⁄AC IN connector (13)
Used to connect the printer to a wall outlet
with the supplied power cord.
9
Introduction