Installing The Printer Driver On The Computer - Sony UP-D890 Gebrauchsanweisung

34 GAMMA switch
5 POSTFEED switch
6 COMMAND switch
78RESERVED switch
Installing the printer driver on the
computer
Install the supplied printer driver on the computer. Follow the instructions in the
"readme.txt" file in the printer driver disk.
Set the GAMMA switch to the desired printing tone.
Print mode
TONE I
TONE II
TONE III
* You can print in TONE I with the 4 GAMMA switch set to either position;
however, we recommend leaving the switch at the factory-set position (ON).
The diagram below shows the curve of each tone for your reference.
High
Low
0
Set how much of printing paper is fed after printing.
ON to feed out extra blank paper after printing;
OFF to save paper by feeding only a short length of paper after printing.
If you use the printer on the application software for UP-D860, set to OFF
(D860). In this setting, the dot density increases and the printed picture
becomes smaller by 10 % horizontaly and verticaly.
Keep this switch set to ON.
GAMMA switch position
3 4
OFF (TONE I) ON or OFF*
ON (–) OFF (TONE II)
ON (–) ON (TONE I)
255
Gradation
27
Preparation