Connecting the Computer
Connecting the Windows Computer
Parallel data cable
a)
(not supplied)
to Parallel interface
connector
a) Hewlett Packard C2950A, etc.
12
Preparation
The YP-D2551PT connects to either of the computer Windows or Macintosh via
the parallel interface.
Notes
• Turn off the power of each device before attempting to make any connections.
• Grab the connector at the end of the connecting cable, and firmly insert it into the
socket.
Notes
• Use the shielded cable that should be less than 3 meters and conforms to the
parallel specification, as the printer cable.
• To use the printer in ECP mode, use an interface cable in conformity to IEEE
STD 1284 such as Hewlett Packard C2950A.
Computer
Note
The parallel cable connection requirement can vary between different computers
and peripherals. For the details of your installation, refer to the manual of your
computer and peripherals.
Fasten the clamps at both sides of the interface
connector to secure the printer cable.
AC power cord
(supplied)
~
AC IN
to ⁄AC IN
to wall outlet