Installation; Connecting The Power Cord; Startup And Shutdown - Sony SnapLab UP-CR25L Bedienungsanleitung

Installation

Connecting the Power Cord

Connect the power cord to the ~ AC IN connector on the
back of the unit, and then connect the plug to a power
outlet.
UP-CR25L
to - AC IN
connector
AC power cord
(not supplied)
To secure the power cord
Wrap the cable clamp around the power cord, and fasten it
securely as shown.
24
Installation

Startup and Shutdown

Startup
1
Verify that no memory card is inserted in any of the
front-side memory card slots of the unit. Then turn on
the POWER switch.
The unit starts up, and the Start Guide screen appears.
If the ink ribbon or paper roll is empty, the following
screen appears.