Bartscher 900-Serie Bedienungsanleitung Seite 47

SUBSTITUTING COMPONENTS
ATTENTION! Before carrying out any substitutions, make sure that the appliance is
disconnected from the electric mains and that the gas cut off valve is closed.
Safety Thermostat (figg.11, 19- pagg.6, 7)
To substitute the thermostat, it is necessary to remove the knobs, the drip pan and the control panel,
as shown in figure 11; then the bulb situated in the front part of the appliance, may be taken out,
removing the fixing plate of the bulb (1) by unscrewing the appropriate screw (2). Next, it is
necessary to unscrew in sequence, the pipe union of the pipe which goes to the burner (3), the pipe
union of the pilot burner pipe (4), the thermocouple (5) and finally, the pipe union of the ramp (6).
Then substitute the part.
Thermocouple
To substitute the thermocouple of the fry-top, it is necessary to remove the knobs, the drip pan and
the control panel. It is then necessary to unscrew the fitting of the thermocouple on the cock and the
one on the pilot unit, then substitute the part.
Elements (figg.11, 17 – pag.6)
To substitute the elements, firstly it is necessary to remove the knobs, the drip pan and the control
panel, as shown in figure 11 (pag.6); then remove the hotplate fixing plates and the bulb fixing
plates situated below the hotplate; after that, lift up the front part of the hotplate (fig. 20) by about 5
cm, move it slightly forward so that the lever which blocks the hotplate at the back, comes out; then
turn it over towards the right. Next, unscrew the fixing screws of the covering (2), remove the
covering (3) and disconnect the element (4) to be substituted, then remove it.
Electric components of the electric fry-top (fig. 18- pag.6)
For the replacement of the selector (4), of the thermostat (5) of the safety thermostat (6), of the
lamps (1), and of the main terminal board (5) of the electric fry-top, it is necessary to unscrew the
fixing screws of the control board (as shown at fig.11 on pag.6), remove it, then disconnect the
electric cables of the component and replace it. After the replacement, connect the electric cables
following the instructions of the wiring diagram.
Information for electrical and electronic devices used in EU countries
According to EU directives, devices marked with the following symbol , may not be disposed
of together with normal household waste.
To dispose of your used device, please use the locally available differentiated collection system or
consult your retailer when you buy an equivalent product.
By actively using the provided collection systems, you are contributing to the reuse, recycling and
enhancement of electrical or electronic devices and protecting the environment and health.
Abusive product disposal is punishable by law in accordance with current legislation.
Pag. 47/68