Registering The Handset For The First Time - Auerswald COMfortel M-530 Betriebsanleitung

1. Press the control key
marked in the display.
2. Press the right-hand key directly under the display to activate the language.
3. Exiting the menu: Press the Disconnect key for a long time.
If you need to display the menu again, do this:
1. Press the middle of the control key
2. Slowly press the

Registering the Handset for the First Time

These instructions describe how to register the telephone on a COMfortel WS-
500S or COMfortel WS-500M base station for the first time.
Requirements:
• The handset has been configured in the base station
• Registration has been triggered in the base station.
Note: You can configure the base station manually or by provisioning via
the PBX. Please refer to the base station Operation Guide for instructions.
Note: You can find out the handset's IPUI on the packaging label or scan
it in. Alternatively, you can view the IPUI on the display. To do so, press
the centre of the control key
The first entry you see is the IPUI. Example: 1: 029E74A560
When you first commission the handset, the message Please register
handset is displayed when you select the language.
• Press the Register key to confirm the message Please register handset
on the handset.
The system displays a clock symbol and the message Searching for a
base in registration mode.
When registration has completed, the handset changes to the idle state. The
handset's name is displayed in the display. If not, repeat the procedure.
The telephone is now ready for use!
COMfortel M-530 - Instructions V02 08/2019
until the required language, e.g. Français, is
.
and keys, one after the other.
to display the menu, In it, enter *#06#.
Initial Commissioning
25