Initial Commissioning
Charging Batteries
•
Before you use the handset for the first time,
put it in the charging cradle and fully charge
the rechargeable batteries.
The rechargeable batteries are fully charged
when the lighting flash symbol
Caution: The handset must be charged in the charging cradle supplied
with it!
Note: The rechargeable batteries might warm up during charging. This is
not dangerous. For technical reasons, the charging capacity of the
rechargeable batteries reduces over time.
Selecting a Display Language
The language setting display is displayed. The set
language (e. g. English) is marked (
1.
Press the control key
e.g. Français, is marked in the display.
2.
Press the right-hand key directly under the display to activate the language.
3.
Exiting the menu: Press the Disconnect key for a long time.
If you need to display the menu again, do this:
1.
Press the middle of the control key
2.
Slowly press the
Registering the Handset for the First Time
These instructions describe how to register the telephone on a COMfortel WS-
500S or COMfortel WS-500M base station for the first time.
Requirements:
•
The handset has been configured in the base station
•
Registration has been triggered in the base station.
Note: You can configure the base station manually or by provisioning via
the PBX. Please refer to the base station Operation Guide for instructions.
Note: You can find out the handset's IPUI on the packaging label or scan
it in. Alternatively, you can view the IPUI on the display. To do so, press
the centre of the control key
The first entry you see is the IPUI. Example: 1: 029E74A560
24
goes out in the display.
until the required language,
.
and
keys, one after the other.
to display the menu, In it, enter *#06#.
COMfortel M-510 - Instructions V02 08/2019
Deutsch
= selected).
English
Français