Working With Connector (Only Z14 Fresh 230V Model); Final Operation Signal (Z14 230V Models); Safety Systems - Zummo Z14 Bedienungsanleitung

When this screen is displayed, find number 1001 - pressing ON moves through the two digits on the
right, and pressing SELECT moves through those on the left – then press STOP (when you press
STOP the display will show ----) and then turn the machine off by the main power switch (if the
machine is not turned off, you cannot move out of this display).
When you turn the machine on again (you will first see the programme version and then code 1001)
the ON and SELECT buttons will have been enabled and machine is now ready to select the number
of oranges you want to squeeze and start operating when you press the ON button.
TO TURN ON THE SELF-SERVICE FUNCTION AGAIN
Repeat the process by entering the code 4104. This will disable the ON and SELECT buttons and the
machine will start working when you turn on the tap.
9
WORKING WITH CONNECTOR (Z14 fresh 230V model)
Repeat the 8 section process by entering the code 3003.
When you turn the machine on again (you will first see the programme version and then code 3003)
the ON button will have been disabled and machine is now ready to select the number of oranges you
want to squeeze and start operating with connector.
TO TURN ON THE NORMAL OPERATING MODE
Repeat the process by entering the code 1001. This will enable the ON button and the machine will
start working when you press the ON button or with connector.
10

FINAL OPERATION SIGNAL (Z14 230V models)

To activate the beep signal, repeat the 8 section process by entering the code 8548. After connecting
the machine when the machine finish a service the machine beeps.
TO DEACTIVATE THE BEEP SIGNAL
Repeat the process by entering the code 8548.
11

SAFETY SYSTEMS

The machine has various safety systems:
1 If the Front Cover is not assembled or is improperly assembled, the display will show an
Error message with the Front Cover and Hopper symbols flashing.
2 If the tray is not assembled or is not in place, the machine will not operate and the display
will show an Error message by displaying a flashing dark tray.
3 If for any reason the machine gets blocked during operation, after a few seconds the motor
will stop automatically and the display will show an Error message with a faulty flashing
icon, until the cause of the blockage is removed.
19