Working With Connector; Z14 Fresh 230V Model ); Final Operation Signal; Z14 230V Models ) - Zummo Z14 Bedienungsanleitung

6.5. WORKING WITH CONNECTOR (

Repeat the 7.2. section process by entering the code 3003.
When you turn the machine on again (you will first see the programme version and then code 3003)
the ON button will have been disabled and machine is now ready to select the number of oranges you
want to squeeze and start operating with connector.
TO TURN ON THE NORMAL OPERATING MODE
Repeat the process by entering the code 1001. This will enable the ON button and the machine will
start working when you press the ON button or with connector.

6.6. FINAL OPERATION SIGNAL (

To activate the beep signal, repeat the 7.2. section process by entering the code 8548. After
connecting the machine when the machine finish a service the machine beeps.
TO DEACTIVATE THE BEEP SIGNAL
Repeat the process by entering the code 8548.

6.7. CLEANING

The machine squeezing area and parts must be cleaned daily.
•
If the machine is in operation, stop it always using the Programmer button Stop. Never attempt to
stop the machine using the main switch. Failure to follow this recommendation will cause the
machine to stop in a position that impedes cleaning; possibly leading to breakage of parts due to
poor handling.
•
Disconnect the machine turning the power switch off. (Fig. 3) Then the digital display will turn off.
(Fig. 4).
•
Remove the Front Cover and wash it using a damp cloth. (ATTENTION!: NEVER use products that
may scratch it).
•
Z14 Model:
- Remove the Filter tray to get access to the Juice tray fastening nuts.
- Juice tray and Blade are removed by unscrewing the fastening nuts and pulling outwards
horizontally.Unscrew the Balls inside the Juice tray (Fig. 5). You may use a dishwasher to wash
Juice tray, Filter, Filter Tray and Blade. TAKE EXTRA CARE WITH THE BLADE (Fig. 12) since
it is very sharp and may cause injuries.
•
Z14 Self-service Model:
- Faucet tray, Juice tray and Blade are removed by unscrewing the fastening nuts and pulling
outwards horizontally. Unscrew the Balls inside the Juice tray (Fig. 5). There is one washer
underneath each Ball. Be careful not to lose them! You may use a dishwasher to wash Juice
tray, Filter and Blade (except the faucet tray). TAKE EXTRA CARE WITH THE BLADE (Fig.
12) since it is very sharp and may cause injuries.
- Wash the faucet tray using a damp cloth. (¡ATTENTION!: NEVER use products that may scratch
it).
•
Remove the Cups unscrewing the Fastening Nuts, and wash them.
•
Remove and wash the Plastic Bins and the Bins Base.
•
Once all plastic parts have been removed, clean the machine stainless steel front.
Z14 fresh 230V model
)
Z14 230V models
)
27