Installation - Zummo Z14 Bedienungsanleitung

 To prevent any risks, all repairs should be performed by technical personnel.
 ZUMMO assumes no liability whatsoever if damage is due to improper machine use or failure to
follow the instructions contained in this manual.
 Request technical service to the distribution company that supplied your machine; in the event that
you cannot locate it, contact the factory (data on the cover of this manual).
 The appliance should not be used by people (including children) with limited physical, sensory or
mental capabilities, or lack of knowledge or experience, unless they are properly supervised or
have been given instructions. Children must always be supervised to ensure they do not play with
the appliance.
 This appliance is designed to be used for domestic and analogue use, such as:
-Kitchen areas for the staff of shops, offices and other workplaces;
-Farmhouses;
-Guests in hotels, motels and other residential-type establishments;
-Accommodation environments such as hotel rooms.
3

INSTALLATION

 Attention! The machine weighs 55 kg. When moving the machine, we suggest that this should be
accomplished by two people. The best way to lift the machine is to grab the rear of the machine
from underneath, with one hand and with the other hand, grab the squeezing tray from underneath,
as well. (Fig. 6)
 Place the machine on a sufficiently sturdy and stable base.
 Make sure that the machine's voltage and frequency match the values of your electrical installation.
See the identification plate. (Fig. 2)
 Use an electrical outlet equipped with an effective ground connection (0.03A). This outlet should be
used exclusively by the juice extraction machine. Do not plug other appliances into the outlet.
 Before operating the machine, wash all machine parts that will be in contact with juice: Balls, Blade,
Juice tray, Filter Tray, Filter and Front Cover.
 Turn ON the power switch (Fig. 3 ( I=On, O=Off )). If no message appears on the display (Fig. 4),
there is lack of power supply. Make sure you have connected the plug to a powered circuit and that
the power switch is switched on. Once this is done, the Programmer display will show one of the
following messages:
a. (Z14 Model) If the display shows a number (Disp. 2a), the machine is ready to start operating.
(Self-service Model) If an orange icon is displayed on the digital screen (Disp. 2b), the
machine is ready to operate.
b. If the display shows the Error message (Disp. 5), then the Front Cover is not in place, and it
should be place it correctly.
c. If the display shows the Error message (Disp. 6), the Juice Tray is not correctly assembled
and should be re-assembled correctly.
16
(Disp. 2a)
(Disp. 5)
MEM
(Disp. 9)
(Disp. 2b)
(Disp. 6)