Installation; Start Up - Zummo Z1 Bedienungsanleitung

3

INSTALLATION

 Important! The machine weighs 29.5 kg. The machine should always be moved by two people. The best
way to lift the machine is to use one hand to get a grip underneath the machine rear and the other hand
placed beneath the Squeezing Tray. (Fig. 4)
 Place the machine on a sufficiently sturdy and stable base.
 Fit all the parts in the correct position. You can see assembly in point 10 (cleaning).
 Make sure that the machine's voltage and frequency match the values of your electrical installation. See
the identification plate. (Fig. 5)
 Use an electrical outlet equipped with an effective earth connection (0.03A). This outlet should be used
exclusively by the juice extraction machine. Do not plug other appliances into the outlet.
 Before operating the machine, wash all machine parts that will be in contact with juice; Cup, Ball, Blade,
Juicer tray, Filter Tray, Filter and Front Cover.
 Turn ON the power switch (Fig. 6 (I=On, O=Off)). If no message appears on the display (Fig. 7), there is
lack of power supply. Make sure you have connected the plug to a powered circuit and that the power
switch is switched on. Once this is done, the Programmer display will show one of the following
messages:
a. If the display shows a number (Disp. 1), the machine is ready to start operating.
b. If the display shows the Error message (Disp. 2), then the Front Cover is not correctly assembled
and should be re-assembled correctly.
c. If the display shows the Error message (Disp. 3), the Juicer tray is not correctly assembled and
should be re-assembled correctly.
d. If the display shows the Error message (Disp. 4), the upper protective device is not properly fitted
and should be re-fitted correctly.
e. If the display shows the Error message (Disp. 5), the bin is not fitted properly and should be re-fitted
correctly.
f. If the display shows the Error MEM (Disp. 6), it means the Programmer is faulty. Contact your local
supplier for technical assistance.
4

START UP

Choose the right cup and ball size, depending on the size of the oranges you intend to juice, and check

whether you need to add the rubber accessory. See chapter on MACHINE ACCESSORIES.
 Depending on the size of ball you have chosen, you should fit the rubber accessory to the guide plate.
(Figs. 8 - 9)
 Fit all parts in the correct position. You can see assembly in point 10 (cleaning).
 Once the machine is switched on, the display will show either a number between 1 and 50 or the letter
C. The number indicates the quantity of fruits to be squeezed, while the letter C sets the machine to
squeeze continuously for approximately 30 minutes.
 To set the number of oranges to squeeze, press the SELECT button repeatedly to increase the number
(from 1 to 50, followed by the letter C; 1,2,3,..........48,49,50,C,1,2,3.....). Alternatively, press and hold the
SELECT button for 2 seconds and the number will decrease. Continue until you visualize the wanted
number.
14
(Disp. 1)
(Disp. 3)
(Disp. 5)
(Disp. 2)
(Disp. 4)
(Disp. 6)