Installation, Programming And Maintenance; Installation - Zummo Z1 Nature Bedienungsanleitung

7. INSTALLATION, PROGRAMMING AND MAINTENANCE


It is compulsory for the machine to be earthed to avoid the possibility of people being given shocks
or damage to the equipment.

The plug must be easily accessible once the installation is complete. The use of extension cables,
adaptors and multiple sockets is not permitted.

7.1. INSTALLATION


Important! The machine weighs 29.5 kg. The machine should always be moved by two people. The
best way to lift the machine is to use one hand to get a grip underneath the machine rear and the
other hand placed beneath the Squeezing Tray (Fig. 14).

Place the machine on a sufficiently sturdy and stable base.

Make sure that the machine's voltage and frequency match the values of your electrical installation.
See the identification plate (Fig. 15).

Use an electrical outlet equipped with an effective earth connection (0.03A). This outlet should be
used exclusively by the juice extraction machine. Do not plug other appliances into the outlet.

Before operating the machine, wash all machine parts that will be in contact with juice; Cup, Ball,
Blade, Juicer tray, Filter Tray, Filter and Front Cover.

Turn ON the power switch (Fig. 9 (I=On, O=Off)). If no message appears on the display (Fig. 16),
there is lack of power supply. Make sure you have connected the plug to a powered circuit and that
the power switch is switched on. Once this is done, the Programmer display will show one of the
following messages:
a. If the display shows a number (Disp. 1), the machine is ready to start operating.
b. If the display shows the Error message (Disp. 2), then the Front Cover is not correctly
assembled and should be re-assembled correctly.
c. If the display shows the Error message (Disp. 3), the Juicer tray is not correctly assembled and
should be re-assembled correctly.
d. If the display shows the Error message (Disp. 4), the upper protective device is not properly
fitted and should be re-fitted correctly.
e. If the display shows the Error message (Disp. 5), the bin is not fitted properly and should be re-
fitted correctly.
f. If the display shows the Error MEM (Disp. 6), it means the Programmer is faulty. Contact your
local supplier for technical assistance
(Disp. 1)
(Disp. 3)
(Disp. 5)
(Disp. 2)
(Disp. 4)
(Disp. 6)
32