Jula Axley Bedienungsanleitung Seite 28

References to right and left are from the operator's position while seated on the towing vehicle.
1. Mount the angle bracket on the chassis using an M8x16 bolt and M8 lock nut. Make sure the bracket is positioned as illustrated (fig. 1).
2. Cut off the plastic tie holding the height adjustment in place.
3. Fit the right hitch rod on the chassis using an M6x40 bolt and M6 lock nut (fig. 2). Do not tighten fully yet. Fit the left hitch rod in the
same way.
1
Hex lock
Angle bracket
nut M8
4. Fasten the two hitch rods together using two M8x65 bolts and two M8 lock nuts (fig. 3). Do not tighten fully yet.
5. The sweeper hitch is mounted in different ways, depending on the height of the tractor/lawnmower hitch (figs. 4 and 5).
6. Tighten all nuts and bolts. Start with those fastening the hitch rods to the chassis. Next, tighten those fastening the front part of the
hitch rods together. Finally, tighten the nuts and bolts on the hitch.
7. Fit the locking pin, spacers and cotter pin (fig. 4 and 5).
3
M8x65
hex bolt
M8 hex
lock nut
8. Assemble the height adjustment handle. Use two M8x40 bolts and M8 lock nuts (fig. 6). Do not tighten fully yet.
9. Fit the grip onto the adjustment handle (fig. 6).
10. Insert an M8x20 bolt through the angle bracket. Then onto the bolt fit a bushing, height adjustment strap, washer and an M8 lock nut
(fig. 7). Tighten.
11. Assemble the remaining parts of the height adjustment (fig. 8).
6
Height adjustment
handle
M8x20
hex bolt
Spacer bushing
M8 lås-
skruv
M8x40
hex bolt
ASSEMBLY
2
M8x16
hex bolt
M6x40
hex bolt
4
Hitch pin
Hitch bracket
Spacer
Hitch bracket
(straight)
Ø3 hair cotter pin
7
M8x20
Big flat
washer Ø8
M6 hex
lock nut
5
M8x50
hex bolt
Hitch bracket
(straight)
M8 hex
lock nut
Hitch bracket
8
Ø8
M8
M8x50
hex bolt
Hitch pin
Spacer
M8 hex
lock nut
Ø3 hair cotter pin
M8x30
EN
27