TERMA VOLTAN Anleitung Zur Montage Und Verwendung Seite 11

a. for 5 s — the heater turns off (single flash on the interface);
b. for 10 s — the heater will be put to sleep(stand-by) mode (single flash on
the interface).
c. for 15 s — enter pairing mode (AP), the entire interface will flash 3 times;
d. for 25 s — restore factory settings and start the pairing mode, the device
will flash as it did at set-up;
6. If the panel of the device has been blocked (the PARENTAL CONTROL
function in the control application), pressing the „+" key for 5 seconds will
release the lock for 1 minute, which will allow you to change the settings
manually on the device without the need to use the application (confirmation
by flashing interface). The change made on the device manually is valid until
the next automatic temperature change saved in the schedule.
ADDITIONAL COMMENTS ON ADDING
DEVICES TO THE TERMA SMART SYSTEM
• Adding devices is possible only via the mobile application.
• System changes are sent locally by the router, and to the cloud service by
the application.
• In some Android system overlays, during pairing, the phone tries to automa-
tically switch to the remembered Wi-Fi network with Internet access — you
must manually confirm the connection with the device's network.
• After adding the heating devices to the system, they are turned off by
default (they do not heat up, despite the low ambient temperature, the inter-
face bars are not lit, and the remote communication interval is 1 h).
• Heating devices should be added first, followed by the sensors.
EN
11