TERMA VOLTAN Anleitung Zur Montage Und Verwendung Seite 3

4. The circuit in the electrical installation to which the radiator is connected
must have an appropriate over-current switch and a residual-current device
(R.C.D.) with a sensitivity of 30 mA.
5. In a wet room installation is only possible at the location and as described in
the IEC 60364-7-701 standard.
6. Do not use extension cords or socket adapters to power the radiator.
7. The place where the radiator is connected to the electrical system must not
be behind or directly above the radiator
8. Before connecting the radiator to the power supply, make sure the power
cord is not mechanically damaged. In case of damage, immediately contact
the seller or the manufacturer.
9. The device is made in protection class II.
10. When connecting the device permanently to the installation, observe the
following guidelines:
a. brown conductor – connection to the phase circuit (L).
b. blue wire – connection to the neutral circuit (N).
11. Make sure the radiator has been installed on the wall in accordance with the
installation instructions (included in the mounting kit).
12. Make sure that the power cord does not come into contact with the hot
EN
OK
3