TERMA VOLTAN Anleitung Zur Montage Und Verwendung Seite 9

a. The new device can be started with a short press on either of the „+" or
„−" buttons on the front panel.
b. If the pairing mode does not start automatically, or if the device is re-
started, press both buttons „+" and „−" simultaneously and hold them for
approx. 15 seconds (the entire display flashes every 5 seconds, after the
third flash, release the buttons).
NOTE: from now on, the device broadcasts its network address (signal) and
is seen by the SMART application.
c. Launch the SMART application and go to the Devices screen.
d. Select the „+" button and follow the instructions in the application (first
scan the code from the sticker on the device or enter it manually, select
the local Wi-Fi network and enter the router password, then from the
list of available devices, select the device currently being added. Finally,
confirm your Wi-Fi network).
ON/OFF
EN
All LED strips will flash three times and the. „+" and „−"
buttons will flash steadily, the device will go into PAIRING
MODE for 5 minutes.
All LED strips will flash 3 times and the „+" and „−" buttons
will start flashing steadily, the device will go into PAIRING
MODE for 5 minutes.).
9