Using Ci Menu And Rebooting The Cam - axing MIP 8-00 Betriebsanleitung

Operation instructions | MIP 8-00 | MIP 16-00 | MIP 8-06 | MIP 16-06
6.2.1.

Using CI menu and rebooting the CAM

The content of the CI menu depends on the CAM manufacturer and the card being used. Depending on the manufacturer,
various settings are possible. Information on validity and authorisation are the most important.
 Please observe the operating instructions provided by the manufacturer.
According to the used CAM different settings can be done. Most important is getting information about authorisation.
The input and navigation field is used for navigation within the CI menu.
 Use Up or Down to reach a higher or lower selection point.
 Use Ok to enter a corresponding sub menu or confirm a selection.
 Use Menu to come back to the next superordinate level.
 Use Exit to leave the menu.
Bit rate
The bit rate is factory set to "Auto". The bitrates of the most common CAM are thus recognized. If necessary, the bit rate can
also be set manually.
 Select the desired bitrate in the Bitrate field.
 For example, select 105 Mbps for a high-speed CAM
Reboot the CAM
The CAM can be rebooted if necessary.
 Click CI1...6 to reboot it.
Page 44 of 48 BA_MIP-8-16-0x.pdf | Technical improvements, changes in design, printing- and other errors reserved. | 2022-02-03
The Content depends on used
CAM
Input and navigation field