Configuration - axing MIP 8-00 Betriebsanleitung

Operation instructions | MIP 8-00 | MIP 16-00 | MIP 8-06 | MIP 16-06

3. Configuration

The device is configured via the graphical user interface of the integrated web interface.
To access the user interface, you need a standard PC/laptop with a network interface and the actual version of the installed
web browser. To connect the network interface of the device to the computer, you need a commercially available network
cable.
The HTTP protocol is used for communication allowing a worldwide remote maintenance of the systems at various locations
via the Internet. Access protection is implemented by means of the password prompt.
IP address:
Subnet mask:
The computer and the device must be in the same subnetwork. The network part of the IP address of the computer must be set
to 192.168.0. and the subnet mask must be set to 255.255.255.0.
The host part of the network address is required for the identification of the devices and can be assigned in the subnetwork
only once. You can allocate to the computer any not allocated host address between 0 and 255.
Hint:
Change the IP address and the subnet mask of your computer accordingly.
(e.g.: IP address:192.168.0.11 and subnet mask: 255.255.255.0)
Control panel > Network connections > LAN connection >Properties > Internet protocol version 4 TCP/IPv4 > Properties > Use
the following IP address:
 Click OK to save.
 Start your web browser and enter the IP address of the device: 192.168.0.145.
Page 12 of 48
192.168.0.145
255.255.255.0.
BA_MIP-8-16-0x.pdf | Technical improvements, changes in design, printing- and other errors reserved. | 2022-02-03