Inputs/Multituner - axing MIP 8-00 Betriebsanleitung

Operation instructions | MIP 8-00 | MIP 16-00 | MIP 8-06 | MIP 16-06
1.3.

Inputs/multituner

Devices with multituner can receive DVB-S/S2/S2x, DVB-T/T2 or DVB-C.
For receiving DVB-T/T2 or DVB-C the LNB power has to be switched off before connecting a antenna cabel to one
of the HF inputs (see 4.1.2 on page 16)!
Direct connection to the LNBs
The devices have a remote supply voltage for the LNB and DiSEqC 1.0 functionalities at the inputs. The inputs can be
connected directly to the LNB.
Multiswitches as input distributors (recommended)
Optionally, you can also use multiswitches as input distributors. The advantage of this solution is that you can set both the
polarization and the satellite via the user interface. Changes in the list of programmes can be made using remote
maintenance, so that it is not necessary to change or modify the input distribution on site.
Demodulation of the data stream
The selection of the frequency and the demodulation of the data stream are both done in the tuner.
Page 6 of 48 BA_MIP-8-16-0x.pdf | Technical improvements, changes in design, printing- and other errors reserved. | 2022-02-03