Output; Select Transport Stream Output - axing MIP 8-00 Betriebsanleitung

5.2.

OUTPUT

5.2.1.

Select transport stream output

Under TS OUTPUT, the type of transport stream and the number of transport stream packets are selected. Depending on the
configured transport stream, the output signals are output as MPTS (Multi Program Transport Stream) or as SPTS (Single
Program Transport Stream). You will configure in PHASE 2 and PHASE 3 according to your selection.
 In the Select TS Outbox box, select MPTS or SPTS.
 In the TS packets per IP packet field, select the number of TS packets.
 Click SAVE & REBOOT.
The changes are made. The remaining time is displayed.
 After rebooting log in again.
2022-02-03 | Technical improvements, changes in design, printing- and other errors reserved. | BA_MIP-8-16-0x.pdf Page 33 of 48