Fill Level; Selected Programmes - axing MIP 8-00 Betriebsanleitung

Operation instructions | MIP 8-00 | MIP 16-00 | MIP 8-06 | MIP 16-06
4.3.3.

Fill level

The fill level depends on the number of activated channels in Phase 2.
The data rate of the channels on the DVB-S/S2/S2x transponders may vary depending on the image contents and on the
transmission quality. To ensure an undisturbed reception, a reserve must absolutely be observed.
We recommend you to set the maximum fill level to 95%. If the current fill level exceeds the maximal fill level, it may cause
image disturbances, such as mosaic images. The error LEDs on the front panel will light up in red in this case.
4.3.4.

Selected Programmes

The programme table SELECTED PROGRAMS shows the programmes that were activated in phase 2.
Page 30 of 48 BA_MIP-8-16-0x.pdf | Technical improvements, changes in design, printing- and other errors reserved. | 2022-02-03